Repairing Inflatable Kayak Seam Tear due to Over-inflation

Moderators: chrstjrn, krudave

Post Reply
wchoe
recent arrival
Posts: 1
Joined: Sat Dec 28, 2019 2:38 am

Repairing Inflatable Kayak Seam Tear due to Over-inflation

Post by wchoe »

I have an Intex Explorer K2 inflatable kayak which has developed a tear in the seam on the stern, due to over-inflation. (see attached picture)
There is no air-leaking as the tear is not on an air-chamber, however, water can come into the kayak as it's just above the waterline.
While I can apply a vinyl patch with glue, I'm concerned that the pressure from inflating the kayak, will open up the tear again.

Please let me know if anyone can provide some advice on this.

Thanks
Attachments
20191227_221109.jpg
20191227_221109.jpg (69.29 KiB) Viewed 513 times

arcprof
forum fanatic
Posts: 53
Joined: Tue Dec 03, 2013 10:56 pm
Location: Auckland New Zealand

Re: Repairing Inflatable Kayak Seam Tear due to Over-inflati

Post by arcprof »

Looks as if a welded seam has let go and will be tricky to get it flat to apply a patch. I'd suggest you stitch it together with needle and thread to get it back to the original shape then gently inflate the tubes to get it somewhere near the inflated shape. Don't put too much stress on the seam as the stitches will rip through. Now you can apply a patch. H66 glue is good for this type of repair.
Cheers Jim
Folbot:Super, Sporty, Greenland II, Klepper:1960's AE2, 1970's AE2, 1990's AE2000

Post Reply

Return to “Kayak Repair”

Who is online

Users browsing this forum: No registered users